Mechanical Alarm Watches: How They Work and How to Use One

Mechanical Alarm Watches: How They Work and How to Use One

A mechanical alarm watch rings using a second, separate mainspring and a small hammer, with no battery. You wind the alarm spring and set an alarm pointer to the time you want. When the watch's hour wheel reaches that position, a release lets the alarm spring drive a hammer back and forth against a pin or the case, producing a buzz that lasts several seconds. The first alarm wristwatch appeared in 1914, and the complication peaked in the mid-20th century. Today it's rare, charming and genuinely useful.

How a mechanical alarm works

Part

What it does

Alarm barrel

A second mainspring, wound separately, that powers only the alarm

Alarm setting wheel and pointer

Sets the time the alarm should go off, shown by an extra hand or a rotating disc

Release

A cam on the hour wheel lines up with the setting at the chosen time and frees the alarm train

Hammer

Vibrates rapidly, striking a pin, a membrane or the caseback

Case

Shaped to project the sound; some have a double caseback or sound holes

When the alarm is released, the hammer strikes many times a second, producing a buzzing or chirping sound. It keeps going until the alarm spring runs down, usually for several seconds.

Because the alarm has its own spring, ringing it doesn't drain the energy that keeps the watch running.

How to set a mechanical alarm

Most mechanical alarm watches have two crowns: one for the time and one for the alarm. Exact steps vary, so always follow the manual, but typically:

  1. Wind the watch with the time crown as usual.
  2. Wind the alarm with the alarm crown. On many watches, turning it one way winds the alarm spring.
  3. Set the alarm time by pulling out the alarm crown and turning it until the alarm pointer or disc shows the time you want.
  4. Engage the alarm if the watch has an on/off setting, often by pushing the alarm crown in or out.
  5. Wait for the buzz. It will ring at the next time the hour hand reaches the alarm setting.

Two things to know

  • Most mechanical alarms run on a 12-hour scale. If it's 9 p.m. and you set the alarm for 7, it rings at 7 a.m., but if you set it for 10, it rings at 10 p.m. in an hour's time.
  • They're accurate to within a few minutes, not to the second, because the alarm is set with a small pointer on the dial. Set it a few minutes early for anything time-critical.

A short history

Year

Milestone

1899

Dürrstein & Co. patents the movement of the first mass-produced alarm pocket watch, the basis for later designs

1908

Eterna patents an alarm mechanism for wristwatches

1914

Eterna launches the first alarm wristwatch produced in series; sharing one spring with the movement, its alarm rings only briefly

1947

After five years of development, Vulcain launches the Cricket, with a separate alarm barrel and a resonating caseback, loud enough to wake its wearer. It became famous as a watch worn by U.S. presidents, beginning with Harry Truman

1950

Jaeger-LeCoultre introduces the Memovox ("voice of memory"), with the alarm time set on a rotating inner disc

1950s

Automatic alarm wristwatches arrive, and divers' versions follow, using the alarm to signal the end of planned dive time

1970s onward

Quartz and digital watches make electronic alarms cheap and common

What does a mechanical alarm sound like?

More like a cricket or a buzzing insect than a beep: a rapid metallic chirp. Volume depends on the case design. It's usually enough to wake a light sleeper if the watch is on a nightstand or under a pillow, and to be noticed in a quiet meeting, but it won't compete with a phone alarm in a noisy room.

Mechanical vs quartz alarms

 

Mechanical alarm

Quartz or digital alarm

Power

A second wound spring

Battery

Sound

Buzzing hammer, organic chirp

Electronic beep, sometimes a vibration

Precision

Within a few minutes

To the minute

Repeats daily

Needs rewinding after it rings

Usually repeats automatically

Cost

High; few models are made today

Low

Character

Charming, mechanical, collectible

Practical

Why wear a mechanical alarm today?

  • A reminder without a screen, for a meeting, a parking meter or picking up the kids
  • A travel alarm that never needs charging
  • One of the most useful complications you can actually hear
  • A rare and distinctive watch with a story behind it

Caring for a mechanical alarm watch

  • Let the alarm spring run down occasionally by letting it ring, so the mechanism stays free.
  • Don't force either crown past resistance.
  • Check water resistance. Some alarm watches have sound holes or special casebacks that limit how much water they can take.
  • Service regularly. The alarm adds parts that need cleaning and lubrication with the movement.

How this applies to Vardesso

If a Vardesso model has an alarm, the product page will say whether it's mechanical or quartz, and the manual will explain how to wind, set and turn it off.

Questions and answers

How does a mechanical alarm watch work?

A separate alarm spring drives a small hammer that vibrates against a pin or the case when the watch reaches the set time.

Does a mechanical alarm watch need a battery?

No. It uses a second wound spring for the alarm.

What was the first alarm wristwatch?

Eterna's, launched in 1914 after a 1908 patent, was the first alarm wristwatch produced in series.

Why is the Vulcain Cricket famous?

Introduced in 1947, it was loud enough to be practical and became known as a watch worn by U.S. presidents.

What does Memovox mean?

It's Jaeger-LeCoultre's name for its alarm watches, meaning "voice of memory."

How loud is a mechanical alarm watch?

Loud enough to notice in a quiet room or wake a light sleeper, but quieter than a phone.

Why does my alarm watch have two crowns?

One winds and sets the time; the other winds and sets the alarm.

Is a mechanical alarm 12-hour or 24-hour?

Most are 12-hour, so they ring at the next time the hour hand reaches the setting.

How accurate is a mechanical alarm?

Usually within a few minutes, since it's set with a small pointer.

Does the alarm affect the watch's power reserve?

No. The alarm has its own spring.

How long does a mechanical alarm ring?

Usually several seconds, until the alarm spring runs down.

Are mechanical alarm watches still made?

Yes, but only by a handful of makers, which makes them relatively rare.

Can I use a mechanical alarm watch underwater?

Only if it's designed for it; some alarm cases have sound openings that limit water resistance.

Keep reading

  • What is a watch complication?
  • Power reserve indicators
  • Digital and ana-digi watches
  • Hand-wound mechanical watches

Sources