Power reserve is how long a mechanical watch keeps running from a full wind without being worn or wound again. It is measured in hours or days. Many popular automatic movements run about 38 to 42 hours; newer movements commonly offer 60 to 80 hours, enough to sit through a weekend; and specialist watches run for a week, a month or more. A longer reserve is more convenient, but it isn't a measure of quality, and the last hours of any reserve are usually less accurate than the first.
Where the power comes from
A mechanical watch stores its energy in the mainspring, a coiled ribbon of spring metal inside a drum called the barrel. Winding the crown or, in an automatic, the swinging rotor tightens the spring; the spring then slowly unwinds through the gear train. Power reserve is simply how long that unwinding takes. See How a mechanical watch works.
Typical power reserves
|
Movement |
Beat rate (vph) |
Power reserve |
|---|---|---|
|
ETA 2824-2 |
28,800 |
about 38 hours |
|
Sellita SW200-1 |
28,800 |
about 38 hours |
|
Seiko NH35 |
21,600 |
about 41 hours |
|
Miyota 9015 |
28,800 |
about 42 hours |
|
Omega 8800 |
25,200 |
about 55 hours |
|
Sellita SW200-2 Power+ |
28,800 |
about 65 hours |
|
Rolex 7135 |
36,000 |
about 66 hours |
|
Rolex 32xx family, Tudor MT5602 |
28,800 |
about 70 hours |
|
Powermatic 80 (Swatch Group) |
21,600 |
about 80 hours |
|
Grand Seiko 9SA5 |
36,000 |
about 80 hours |
|
IWC 7-day movements |
|
7 days (168 hours) |
|
Panerai 8-day movements |
|
8 days |
|
A. Lange & Söhne Lange 31 |
21,600 |
31 days |
|
Hublot MP-05 LaFerrari |
21,600 |
50 days |
The Lange 31, introduced in 2007, was the first wristwatch with a month-long reserve. Hublot's MP-05 LaFerrari of 2013 reached 50 days by coupling eleven mainspring barrels; it comes with a power tool for winding.
Why "weekend-proof" matters
Take a watch off on Friday evening and pick it up on Monday morning, and about 60 hours have passed. A 38- or 42-hour movement will have stopped, so you need to wind it and reset the time and date. A movement with 65 to 80 hours will still be running. That simple convenience is why the industry has moved so decisively toward longer reserves over the past decade.
How makers have stretched power reserves
- More efficient escapements. The escapement is where much of a movement's energy is lost. Rolex says almost half of the increase in its calibre 3255's power reserve came from its more efficient Chronergy escapement. See The escapement explained.
- Better mainsprings. Modern spring alloys store more energy in the same space.
- Slower beat rates. A slower balance uses less energy. The Powermatic 80 reaches 80 hours partly by running at 21,600 vph. See Beat rate explained.
- Bigger or more barrels. Two barrels, or a single larger barrel, store more energy. Long-reserve watches often have several.
- Lighter, low-friction parts. Silicon escapement parts and refined gear trains waste less energy.
Each approach involves trade-offs: more barrels add thickness, slower beats change the feel of the seconds hand, and bigger springs need stronger winding systems.
Not all hours are equal
A mainspring pushes hardest when it is fully wound and gently when it is nearly run down. As the force drops, the balance swings less widely, and timekeeping can drift, especially in the last several hours before the watch stops. A watch that is accurate on the first day of its reserve may run noticeably differently on the last.
Fine watchmakers manage this in several ways:
- Limiting the usable reserve. IWC's seven-day movements have springs that could run longer, but they stop the watch after 168 hours so it only runs while the spring's force is strong enough for good timekeeping.
- Constant-force mechanisms. The Lange 31, for example, uses a constant-force device so the balance receives steady power throughout its month-long reserve.
- Keeping it topped up. For everyday watches, the practical answer is simply to wear or wind the watch regularly, so it spends most of its time in the strong part of its reserve.
When your watch runs out
When the mainspring runs down, a mechanical watch simply stops. Nothing is harmed. To restart it:
- Wind it first. On a watch that can be wound by hand, give the crown 20 to 40 turns. On an automatic that can't be hand-wound, gently swing the watch side to side for a minute or so.
- Set the date, avoiding the hours around midnight if the manual warns against it.
- Set the time, ideally using hacking seconds if your watch has them. See Hacking seconds.
- Wear it. An automatic's rotor will keep it going from there.
How to keep an automatic watch running
- Wear it daily. Regular wear normally keeps an automatic wound, though how much it winds depends on your activity. See How long will an automatic watch run off the wrist?
- Top it up by hand on days you're mostly sitting still, if the movement allows hand-winding.
- Use a watch winder if you rotate several automatics and want them always running. It's a convenience, not a necessity.
- Watch the power reserve indicator if your watch has one: a small hand or window on the dial that shows how much energy is left.
How to measure your own watch's power reserve
Wind the watch fully, by hand or by wearing it all day, then set it down at a noted time and leave it untouched. Check it now and then, and note when it stops. Expect a result close to the maker's figure, often a little higher, since makers state figures they can guarantee.
Hand-wound watches
A hand-wound watch has no rotor, so its power reserve is the whole story: you wind it, usually once a day, and it runs until the spring runs down. Many hand-wound owners enjoy this daily ritual. A long reserve makes the habit forgiving if you miss a day. See Hand-wound mechanical watches.
How much power reserve do you need?
- If you wear one watch every day, almost any reserve works. An automatic will stay wound from your movement.
- If you rotate watches or skip weekends, 60 hours or more saves you from resetting the time every Monday.
- If you own a hand-wound watch, 40 hours is enough for daily winding; longer is more forgiving.
- If you love engineering, multi-day and multi-week reserves are a genuine technical achievement worth seeking out.
Remember that a longer reserve doesn't mean a better watch. Accuracy, reliability, serviceability and comfort matter as much or more.
How this applies to Vardesso
Where a Vardesso model uses a mechanical movement, its product page lists the power reserve as the movement maker specifies it, alongside the beat rate. If your routine includes weekends off the wrist, look for models at 60 hours or more.
Frequently asked questions
What does a 42-hour power reserve mean? A fully wound watch will run about 42 hours without being worn or wound.
Does a longer power reserve mean a better watch? No. It means more convenience, often with trade-offs in size or beat rate.
Will my automatic watch stop if I don't wear it? Yes, once its power reserve runs out. It restarts as soon as you wind it or wear it.
Does running out of power damage a watch? No. It simply stops.
How do I know how much power is left? Only a watch with a power reserve indicator shows it directly. Otherwise, wind or wear it regularly.
Do I need a watch winder? Only if you want several automatics always running. Winding by hand works just as well.
Why is my watch less accurate when it's almost run down? The mainspring's force drops near the end of its reserve, and the balance swings less evenly.
Keep reading
- How a mechanical watch works, from mainspring to hands
- How long will an automatic watch run off the wrist?
- Can you overwind an automatic watch?
- Beat rate explained
- Why did my automatic watch stop?