The most common reason an automatic watch stops is simply that it ran out of power: it wasn't worn enough, or long enough, to keep the mainspring wound. Wind it by hand or wear it, and it starts again. The next most common causes are a crown left pulled out, which stops the watch on purpose, and a watch that needs servicing, which typically shows up as stopping much sooner than it should even when fully wound. Less often, a knock, moisture, a jammed date or a broken part is to blame. A few minutes of simple checks will usually tell you which.
Five-minute check
- Is the crown pushed all the way in? If it's pulled out, the watch is stopped by design. Push it in, or screw it down if it's a screw-down crown.
- Wind it. Give the crown 20 to 40 turns, with the watch off your wrist, or gently swing the watch side to side for a minute if it can't be hand-wound.
- Watch the seconds hand. If it starts and keeps running, the watch had simply run down.
- Set the time and wear it, and note when it stops next time, if it does.
- If it doesn't start, or starts and stops again soon, read on.
The common causes
It ran out of power
This is by far the most likely cause. An automatic only winds when your wrist moves, so a quiet day, a weekend in a drawer or a watch that was only partly wound when you took it off can all leave it stopped. It isn't a fault. See How long will an automatic watch run off the wrist?
Fix: wind it by hand, wear it, or top it up in the mornings on quiet days.
The crown is pulled out
On most modern movements, pulling the crown to the time-setting position stops the balance wheel so you can set the time to the second. If the crown was bumped out, or not pushed fully home after setting, the watch stays stopped. See Hacking seconds.
Fix: push the crown in, or screw it down. On a screw-down crown, make sure it's fully home for water resistance too.
It needs servicing
The oils in a mechanical movement slowly thicken and dry over the years. As they do, the movement loses energy to friction, the balance swings less, and the watch may stop well before its rated power reserve, or stop at night when it's off your wrist, even right after a full wind. It may also keep worse time.
Fix: a service by a watchmaker. Most mechanical watches need one every five to ten years or so, depending on the maker and how they're worn.
It was knocked
A hard knock can disturb the movement despite its shock protection: a tangled hairspring, a bent balance pivot, hands knocked loose or a rotor dislodged. See Shock protection.
Signs: the watch stopped right after a drop or a hard knock; a new rattle inside; hands out of line or touching.
Fix: see a watchmaker.
The hands or date are jammed
If the hands have been knocked and are touching each other or the dial or crystal, they can stop the watch. And on many watches, setting the date by hand during the hours around midnight, while the date mechanism is already engaged, can jam or damage it. Your manual will say which hours to avoid.
Signs: the watch stops at the same position each time, often near midnight, or the hands visibly touch.
Fix: a watchmaker can free and realign them.
Moisture got in
Fog or droplets under the crystal mean water or moist air has entered the case, often through a crown that wasn't screwed down, an aged gasket or a cracked crystal. Moisture can rust steel parts quickly.
Fix: see a watchmaker promptly. Don't wait for it to dry out on its own, and don't put it in rice.
Something has broken
Occasionally, a part simply fails: a broken mainspring, a cracked jewel, a worn winding wheel. Modern mainsprings rarely break, but it happens, especially in older watches.
Signs: the crown winds without resistance and the watch never runs, or you can wind and wind and nothing changes.
Fix: repair by a watchmaker.
What about magnetism?
Magnetism usually makes a watch run fast rather than stop, but a strongly magnetized movement can behave erratically and, occasionally, stop. If your watch has been near a strong magnet and is behaving oddly, have it demagnetized first; it takes seconds. See Magnetism and watches.
Symptom guide
|
What you notice |
Most likely cause |
|---|---|
|
Stopped after a few days off the wrist |
Ran out of power |
|
Stopped overnight after a quiet day |
Not fully wound |
|
Crown sticking out |
Crown pulled out |
|
Stops well short of its rated power reserve even after a full wind |
Needs servicing |
|
Stopped right after a knock, or rattles |
Shock damage |
|
Stops at the same time each day, often near midnight |
Hands or date jammed |
|
Fog under the crystal |
Moisture inside |
|
Crown turns freely but the watch never runs |
Broken part, such as the mainspring |
|
Suddenly running very fast, then erratic |
Magnetism |
When to see a watchmaker
- The watch won't run after a full wind.
- It stops well short of its power reserve, even when fully wound.
- There's fog or moisture under the crystal.
- It rattles, the hands are misaligned, or the date won't change.
- It stopped after a hard knock.
- It hasn't been serviced in many years.
If the watch is under warranty, contact the brand or the retailer first, before having it opened elsewhere.
How to avoid it
- Wear it, or wind it, especially on quiet days.
- Push in or screw down the crown every time after setting it.
- Avoid setting the date during the hours your manual warns against.
- Keep it away from strong magnets.
- Service it on the schedule the maker recommends.
How this applies to Vardesso
Where a Vardesso model uses an automatic movement, its manual explains how to wind it, which hours to avoid when setting the date, and how to set the time. If your watch stops and the five-minute check doesn't start it again, contact us before having it opened, especially while it's under warranty.
Frequently asked questions
Why did my automatic watch stop overnight? Most likely it wasn't fully wound. Wind it by hand in the morning, or before you take it off.
Is my watch broken if it stops? Usually not. Most stopped automatics simply ran out of power.
My automatic stops even after I wind it. Why? It may need servicing, or a part may be damaged. See a watchmaker.
Can I shake my watch to start it? Gently swinging it side to side is fine. Don't shake it hard.
Why does my watch stop around midnight? The date mechanism may be jammed, often from setting the date at the wrong time of day.
How often should an automatic be serviced? Typically every five to ten years, depending on the maker.
Keep reading
- How long will an automatic watch run off the wrist?
- Power reserve explained
- Can you overwind an automatic watch?
- Hacking seconds
- Shock protection
- Magnetism and watches