To measure your wrist for a watch, wrap a flexible tape measure, or a strip of paper, snugly around your wrist just above the wrist bone, where a watch sits. Read the measurement where the end meets the tape, or mark the paper and measure it against a ruler. That number, your wrist circumference, tells you which case sizes and strap lengths will fit. For the best fit, also measure the width of the flat top of your wrist, which tells you the longest lug-to-lug length you can wear.
What you'll need
Any one of these:
- A flexible sewing or tailor's tape measure
- A strip of paper or a piece of string, plus a ruler
- A watch or bracelet you already wear comfortably
A pen and a few minutes are all you need beyond that.
Where to measure
Measure where you'll wear the watch: just above the wrist bone (the knob on the outside of your wrist), on the forearm side. Most people wear a watch there, so it doesn't slide over the bone or press on it when the wrist bends.
A few tips:
- Measure the wrist you'll wear the watch on. Most people wear a watch on their non-dominant wrist, and your two wrists can differ slightly.
- Relax your hand. Don't make a fist or flex.
- Measure snugly, not tightly. The tape should touch all the way around without pressing into the skin.
- Measure twice, and if the numbers differ, use the larger one.
Method 1: Use a flexible tape measure
- Wrap the tape around your wrist just above the wrist bone.
- Keep it flat and level, not twisted or slanted.
- Pull it snug, so it touches all the way around without squeezing.
- Read the number where the end of the tape meets the rest of it.
This is the quickest and most accurate method.
Method 2: Use a strip of paper or string
- Cut a strip of paper about 1 cm (½ inch) wide and 25 cm (10 inches) long. A strip of paper works better than string because it doesn't stretch.
- Wrap it around your wrist just above the wrist bone, snug but not tight.
- Mark the spot where the end overlaps, using a pen.
- Lay the strip flat against a ruler and measure from the end to your mark.
Method 3: Use our printable ruler
Our printable wrist ruler is a paper strip marked in both inches and centimeters.
- Download and print the ruler at 100% scale. In your printer settings, choose "Actual size" and turn off "Fit to page" or "Scale to fit."
- Check the print. Measure the check line printed on the sheet with any ruler. If it isn't exactly the length printed next to it, adjust your printer settings and print again.
- Cut out the strip and cut the slot at the zero end.
- Wrap it around your wrist just above the wrist bone and thread the end through the slot.
- Pull it snug and read your size where the strip meets the slot.
Download the printable wrist ruler (PDF) [link this line to the ruler PDF before publishing]
Method 4: Measure a watch you already wear
If you already have a watch that fits well, you can measure it instead:
- On a strap: unbuckle it and lay it flat. Measure from the end of the buckle (where the strap bends around it) along the strap to the hole you use, then add the length of the watch case from lug to lug. That gives a good estimate of your wrist size plus a comfortable allowance.
- On a bracelet: open the clasp, lay the watch flat on its side, and measure the inside circumference by laying a strip of paper along the inside of the bracelet from one side of the clasp to the other.
This measures your preferred fit rather than your bare wrist, which is useful when you're sizing a new bracelet or strap.
How to measure your wrist's width
Wrist circumference tells you about strap length and general size. The width of the flat top of your wrist tells you the longest watch that will sit flat.
- Turn your palm down and look at the top of your wrist where the watch sits.
- Lay a ruler across it from the thumb side to the little-finger side.
- Measure the flat part only, from where the wrist starts to curve away on one side to where it curves away on the other.
That width is your target maximum for lug-to-lug length. See Lug-to-lug.
What to do with your measurement
Find your case size
|
Wrist circumference |
Typical case diameter |
|---|---|
|
Under 6 in (under 15 cm) |
28 to 36 mm |
|
6 to 6.5 in (15 to 16.5 cm) |
34 to 38 mm |
|
6.5 to 7 in (16.5 to 18 cm) |
36 to 40 mm |
|
7 to 7.5 in (18 to 19 cm) |
38 to 42 mm |
|
7.5 to 8 in (19 to 20.5 cm) |
40 to 44 mm |
|
Over 8 in (over 20.5 cm) |
42 mm and up |
See the full Watch size guide.
Choose a strap length
Two-piece straps are usually sold in lengths such as short, regular and long, or by the length of each piece in millimeters (for example, 120/75 mm: 120 mm for the long piece with the holes, 75 mm for the buckle piece). Check each strap's stated wrist range against your measurement. Ideally, you'll fasten the strap on one of the middle holes, leaving room to adjust either way.
Size a bracelet
A bracelet is sized by removing or adding links. Most people like a bracelet with a little room, about the width of a fingertip between bracelet and wrist, so it doesn't pinch when your wrist swells in warm weather. If the clasp has a micro-adjustment, you can fine-tune by a few millimeters without removing links.
How tight should a watch be?
Snug enough that the watch doesn't slide over your wrist bone or spin around, and loose enough that you can slip a fingertip under the strap or bracelet. A watch that's too tight leaves marks; one that's too loose slides around, wears faster and can catch on things. Your wrist can change size during the day and in hot weather, so a little room is better than none.
Common measuring mistakes
- Measuring the wrong spot, such as over the wrist bone or down at the hand.
- Pulling the tape too tight, which gives a size that's too small.
- Using string that stretches.
- Printing the ruler at the wrong scale. Always check the line.
- Adding allowance twice. If you measured a strap you already wear, the number already includes your preferred allowance.
How this applies to Vardesso
Once you know your wrist circumference and width, every Vardesso product page gives you what you need to compare: case diameter, lug-to-lug, thickness and lug width, plus the strap or bracelet details. If you're unsure which size will suit you, send us your measurements and we'll help you choose.
Questions and answers
How do I measure my wrist without a tape measure?
Wrap a strip of paper around your wrist just above the wrist bone, mark where it overlaps, then measure the strip against a ruler.
Where should I measure my wrist for a watch?
Just above the wrist bone on the forearm side, where a watch normally sits.
Should I measure my wrist tight or loose?
Snug: the tape should touch all the way around without pressing into the skin.
Which wrist should I measure?
The one you'll wear the watch on, usually your non-dominant wrist.
What is the average wrist size?
Most adult men's wrists are roughly 6.5 to 7.5 inches (16.5 to 19 cm) around and most adult women's roughly 5.5 to 6.5 inches (14 to 16.5 cm), with a wide range either side.
How do I know my printed ruler is the right size?
Measure the check line on the printout with a ruler. If it doesn't match the length printed beside it, reprint at "Actual size" or 100%.
How do I measure my wrist width for lug-to-lug?
Lay a ruler across the top of your wrist and measure the flat part, from where it curves away on one side to where it curves away on the other.
How much room should a watch have on the wrist?
About a fingertip's width of space between the strap or bracelet and your wrist.
How do I convert wrist inches to centimeters?
Multiply inches by 2.54. A 7-inch wrist is about 17.8 cm.
What size strap do I need for a 7 inch wrist?
Most "regular" straps fit a 7-inch wrist, but check each strap's stated range. You'll ideally fasten it on a middle hole.
Does wrist size change during the day?
It can change slightly with heat, activity and time of day. That's why a little room in the fit is a good idea.
Can I measure my wrist using a watch I already own?
Yes. Measure the strap from the buckle to the hole you use and add the lug-to-lug length, or measure the inside of the bracelet.
How tight should a watch bracelet be?
Snug enough not to slide over the wrist bone, with room to slip a fingertip underneath.
Keep reading
- Watch size guide
- Lug-to-lug
- Watch thickness
- How to choose your first watch
- Do "men's" and "women's" watch labels matter?