Can You Swim or Shower With a Watch? What the Ratings Allow

Can You Swim or Shower With a Watch? What the Ratings Allow

Check your watch's rating first. A 30 m (3 ATM) watch handles splashes and rain, not swimming. 50 m allows brief, shallow swimming at most, and 100 m is a comfortable swimming and snorkeling rating. Skip hot showers, saunas and hot tubs with any watch, keep the crown screwed in or pushed in, and rinse after salt or chlorine.

What does water resistance actually mean?

No watch is waterproof. Watches are water resistant, which means their gaskets and seals keep water out under certain conditions, for a limited time, until the seals age. The number on the dial or caseback comes from a laboratory test. Under ISO 22810, the general standard for water-resistant watches, a sample from a production run is tested under static pressure, meaning still water at a set pressure, in conditions that are mild compared with real life.

That's why a "30 meter" watch isn't safe at 30 meters of depth. In real use, water pressure rises with motion: a dive into a pool, a stroke of your arm or a jet of water from a tap creates momentary pressure far above what the same watch faces when it sits still. Our article on water resistance ratings explains the numbers in detail, and our article on how water resistance works covers the gaskets.

What can each rating handle?

Manufacturers and retailers differ a little on these, and your watch's manual always comes first. This table shows a cautious, widely used reading.

Rating

Also written

Good for

Avoid

Not marked, or "splash resistant"

n/a

Keeping dry; a few drops

All water exposure, steam and humidity

30 m

3 ATM / 3 bar

Rain, handwashing, splashes

Swimming, showering, any submersion

50 m

5 ATM / 5 bar

The above, plus brief, shallow swimming

Snorkeling, water sports, hot showers

100 m

10 ATM / 10 bar

Swimming and snorkeling

Scuba diving, high-speed water sports

200 m or more, marked as a diver's watch

20 ATM / 20 bar

Recreational scuba diving, if it meets the diver's standard

Hot tubs and saunas

Note the last row. A watch marked "diver's" should meet ISO 6425, a stricter standard that tests each watch individually and adds extra checks. A watch that is merely rated 200 m under the general standard isn't automatically a dive watch.

Can you shower with your watch?

It's best not to, whatever its rating. Some makers say watches rated 50 m and up are fine in a quick, cool shower. Others advise against showers for every watch, and that cautious view is the safer one. Here's why showers are harder on a watch than the pool:

  • Heat. Steel, glass and rubber expand at different rates, so hot water can open microscopic gaps at the crown, crystal and caseback that don't exist at pool temperature. Ratings are established in cool, still water.
  • Steam. Water vapor gets past gaskets that would hold back liquid water.
  • Soap and shampoo. They leave a film that can dry out and degrade rubber seals.
  • Pressure and jets. A showerhead aims a focused stream at the case.
  • Temperature shock. Stepping from a hot room to cool air can pull moisture into the case as the air inside cools and contracts, which is how fog under the crystal begins.

A watch can survive many showers before one finally floods it. If you wear a watch to the bath or shower daily, you're wearing out its seals faster than you think.

Can you swim with your watch?

Yes, if the rating allows it and the watch is in good condition.

  • Pool or sea at 100 m or more is comfortable for most watches.
  • A 50 m rating allows a gentle dip. Avoid diving in or vigorous swimming.
  • A 30 m rating is not a swimming rating.

Before you go in, check the crown. A crown left unscrewed, or only half pushed in, is the most common reason a watch floods. After you swim in a pool or the sea, rinse the watch under cool, gentle tap water with the crown still locked, then dry it. Chlorine, salt and sunscreen are hard on gaskets and on metal finishes over time.

What about hot tubs, saunas and steam rooms?

Keep every watch out of them. Heat, steam and chemicals make a tough combination for seals, even in a diver's watch, and the sudden change from hot to cool air is a leading cause of internal fog. This applies to a watch rated for deep diving as much as to a 30 m dress watch.

What should you never do around water?

  • Don't operate the crown or pushers while the watch is wet or underwater, unless the maker says its pushers are made for it. Opening a seal lets water in.
  • Don't wear a leather strap in water. The watch might cope, but the strap won't. Switch to a rubber, fabric or metal strap first.
  • Don't expose the watch to hot water or steam (showers, baths, saunas, hot tubs).
  • Don't dive from a height or wear it for fast water sports unless it's rated and designed for impact.
  • Don't use soap, solvents, perfume or strong sunscreen on the case or gaskets and then wear it in water.
  • Don't blast it with a pressure washer or hold it under a strong jet.

How do you rinse a watch after the sea or the pool?

  1. Make sure the crown, and any pushers, are fully screwed down or pushed in.
  2. Rinse under a gentle stream of cool fresh water for about a minute, moving the watch so water reaches the crown area and bracelet.
  3. Dry it with a soft cloth.
  4. Leave it to air-dry for a few minutes with the clasp open before you wear it.

If you've been in salt water, rinsing helps prevent salt from crystallizing around the crown and in bracelet links.

Does water resistance fade over time?

Yes. Gaskets are rubber or synthetic and age. Heat, chemicals, dryness and impacts wear them down. A watch that was water resistant when new may not be after a few years. If you use a watch around water, ask a watchmaker to pressure-test it from time to time. Many suggest every one to two years for watches used near water, and sooner after a knock or any crown service. Our upcoming guides on servicing cover how often to test.

An impact such as a hard drop can also weaken seals. If the watch has taken a knock, have it tested before you go swimming.

What should you do if water gets in?

  1. Take the watch off and dry the outside.
  2. Don't pull out or turn the crown to "let it out."
  3. Keep it dry and still and contact Vardesso or a watchmaker the same day if you can. Water inside a movement can start corroding it within days.
  4. Don't use a hair dryer, oven or microwave, which can warp seals and damage lubricants.

Our guide to fog under the crystal covers the milder case, where you see only a light mist.

How this applies to Vardesso watches

If your Vardesso watch states a water-resistance rating, use the table above as a cautious guide and keep to what your product page or manual says for that model. If a watch isn't marked water resistant, treat it as splash-averse and keep it away from water. Whatever the rating, avoid hot water and steam, make sure the crown is screwed down or pushed in before any contact with water, and contact Vardesso if you notice moisture inside the case.

Questions and answers

Can I swim with a 30 m water-resistant watch?

No. A 30 m rating means it can handle rain and splashes, not swimming. Choose a watch rated 50 m for a gentle dip and 100 m or more for regular swimming.

Can I shower with a water-resistant watch?

It's best not to. Hot water, steam and soap are harder on seals than a pool, so many watchmakers advise against it for every rating.

Is 50 m water resistance enough for swimming?

For brief, shallow swimming, yes, with care. For regular swimming or snorkeling, choose 100 m or more.

Is 100 m water resistance good enough for swimming?

Yes. 100 m is a comfortable rating for swimming and snorkeling, provided the crown is closed and the seals are healthy.

Can I wear my watch in the sea?

Yes, if it's rated 100 m or more, and rinse it with fresh water afterward. Salt is hard on seals and finishes.

Can I wear a watch in a hot tub or sauna?

No. Heat and steam can get past seals, and rapid temperature change can pull moisture inside, whatever the watch's rating.

What does ATM mean on a watch?

ATM stands for atmospheres of pressure; 1 ATM is about 10 meters of rating. It's a lab test figure, not a depth you can dive to.

Does water resistance last forever?

No. Gaskets age and dry out, and impacts or heat accelerate this. Have a watch you use near water tested from time to time.

How often should I pressure-test my watch?

Many watchmakers suggest every one to two years if you use it near water, and after any impact, battery change or crown service.

Can I scuba dive with my watch?

Only if it's marked as a diver's watch and meets the diver's standard. A general 200 m rating isn't automatically enough.

Can I operate the crown underwater?

No. Make adjustments only when the watch and your hands are dry, then lock the crown again before the watch touches water.

What should I do if my watch gets wet inside?

Take it off, dry the outside, don't turn the crown and contact a watchmaker or Vardesso quickly.

Can I wear a leather strap swimming?

It's not a good idea. Water damages leather. Switch to rubber, fabric or metal before getting wet.

Does salt water damage a watch?

Over time, yes. Salt corrodes metal and wears seals. Rinse with fresh water after every dip.

Keep reading

  • Water Resistance Ratings Explained (/blogs/watch-basics/water-resistance-ratings)
  • How Water Resistance Works: Gaskets, Crowns and Casebacks (/blogs/materials/how-water-resistance-works)
  • How to Use a Screw-Down Crown (/blogs/watch-care/how-to-use-a-screw-down-crown)
  • Fog Under the Crystal: What It Means and What to Do (/blogs/watch-care/fog-under-the-watch-crystal)
  • Anatomy of a Watch (/blogs/watch-basics/anatomy-of-a-watch)
  • How Watch Warranties Work (/blogs/watch-basics/how-watch-warranties-work)

Sources