Is Your Watch Magnetized? How to Test and Demagnetize It

Is Your Watch Magnetized? How to Test and Demagnetize It

 

Excerpt

A watch that suddenly gains minutes a day is often magnetized, not broken. Here is how to test for it in ten seconds, how a demagnetizer works and how to avoid it next time.

Featured image

A small compass beside a Vardesso watch on a plain table, needle visible (own photography).

In-article images

1) A compass-test sequence: watch far away, watch near, needle deflected. 2) A table-top photo of everyday magnet sources (phone case, laptop, speaker, bag clasp). 3) A diagram of a hairspring with its coils stuck together (all own photography or drawings).

Article body starts here

A magnetized watch usually runs fast, sometimes by minutes a day, or runs erratically. To test it, lay a compass flat and move the watch slowly around it: if the needle swings toward the watch or follows it, the watch is probably magnetized. A watchmaker or a small demagnetizer can usually fix it in seconds.

What does it mean for a watch to be magnetized?

Many parts inside a mechanical watch are made of steel or other metals that can pick up magnetism. The part that matters most is the hairspring, a hair-fine coiled spring attached to the balance wheel. The hairspring is what sets the watch's rate. When the hairspring becomes magnetized, its coils attract each other and stick together. A shorter working spring beats faster, so the watch runs fast.

Magnetism is a common workshop problem. It doesn't mean the watch is broken, and in most cases demagnetizing it restores normal timekeeping. Our article on watch magnetism explains the physics, and our article on regulating a watch explains why nothing else needs adjusting once the magnetism is gone.

What are the signs of a magnetized watch?

  • A sudden gain. Your watch was fine last week and now gains tens of seconds, or even minutes, a day.
  • Erratic timekeeping. It runs fast one day and normally the next, with no pattern.
  • Stopping and starting. In severe cases the hairspring locks up and the watch stops.
  • A second hand that ticks unevenly, on some quartz watches.
  • A reaction to a compass, as described below.

If the change is gradual and over months, magnetism is less likely, and age, dry lubricants or low power are likelier causes. Our guide to what to do when a watch runs fast or slow walks through the full list.

How do you test a watch for magnetism?

The compass test takes about ten seconds.

  1. Lay a compass flat on a table and let the needle settle. A cheap hiking compass or a compass app on a phone-sized card works.
  2. Hold the watch a centimeter or two from the compass and move it slowly around, over and across it.
  3. Watch the needle. If it swings toward the watch, or follows it as you move the watch around, the watch is magnetized.
  4. Turn the watch over and try the other side, since the caseback may behave differently.

A phone's built-in magnetometer, used through a free magnetometer app, can show a spike in readings as a magnetized watch approaches. Place the phone's sensor (usually near the top or center) close to the watch, move slowly and compare with a normal reading.

A small deflection isn't proof. Steel bracelets, clasps and case parts can nudge a compass even when the movement is fine. The best confirmation is whether the watch's rate returns to normal after demagnetizing. A watchmaker can also check amplitude and rate on a timing machine.

What causes magnetism?

Most cases come from ordinary things we keep near our watches:

Source

Why it's a problem

Phone and tablet cases with magnetic closures

A strong magnet sits right where you rest your wrist

Phone and tablet speakers

Small but strong magnets

Laptop lids and wireless charger pads

Magnets and magnetic coils

Magnetic handbag, wallet and bag clasps

Strong, often held close to a wrist

Headphones, earbuds and their charging cases

Magnets and coils in a small space

Fridge magnets and magnetic knife strips

Common in kitchens

Magnetic tool holders and power tool motors

Strong fields in workshops

Security gates, some medical equipment

Strong, often unexpected, fields

Exposure over time adds up, and a single close encounter with a strong magnet can do it at once. Many watches are designed to withstand a baseline field. The international standard ISO 764 asks that a magnetic-resistant watch keep its accuracy to within 30 seconds a day after exposure to a field of 4,800 amperes per meter, roughly 60 gauss. A decent refrigerator or bag-clasp magnet can exceed that at close range.

How do you demagnetize a watch?

The simple answer: use a demagnetizer, a small mains-powered device that produces an alternating field which scrambles the magnetism, or take the watch to a watchmaker, who has one and will do it quickly.

If you buy a demagnetizer for home use, it typically works like this. Always follow the instructions that come with yours.

  1. Move your phone, cards and anything electronic away. The device's field can affect them.
  2. Push the crown in fully, screw it down if it screws down, and make sure the watch is clear of loose metal.
  3. Place the watch on the device's recess or just above it, as the instructions say.
  4. Switch the device on (stream-type devices run while you hold a button) and slowly lift the watch away in a smooth motion, keeping it flat, until it is some 30 centimeters (a foot) away. Don't switch the device off while the watch is close to it. A pulse-type device is pressed once, the watch is turned a quarter and pressed again, as its instructions describe.
  5. Switch off only after the watch is far away.
  6. Run the compass test again and then re-measure the watch's rate for a few days.

Some important cautions:

  • Demagnetizers are made for mechanical watches. Don't use one on a quartz, solar, smart or other electronic watch unless the watch's maker says it's safe.
  • Never try to demagnetize a watch with a permanent magnet, or rub it with one. That adds magnetism.
  • If the watch is valuable, sentimental, still under warranty, or the problem comes back, go to a watchmaker.
  • A watch that doesn't improve after demagnetizing has another problem. Don't keep repeating the process.

Can magnetism hurt a quartz watch?

A strong magnet near a quartz watch can disturb the small motor that moves the hands, causing erratic or stalled hands. This usually clears when the magnet is removed. Quartz watches don't have a hairspring, so the rate problem is less common. If a quartz watch misbehaves after magnet exposure and doesn't recover, contact the maker or a watchmaker. Don't use a demagnetizer on it.

Are anti-magnetic watches immune?

No watch is immune, but some are much more resistant. There are two main approaches: shield the movement inside a soft iron cage, which routes the field around it, or make the hairspring and other key parts from non-magnetic alloys, which resist magnetization in the first place. Watches that exceed the ISO 764 baseline may state their resistance in gauss. A watch that's described only as "anti-magnetic" without a figure may just meet the baseline.

How do you prevent magnetism?

  • Keep distance. Magnetic fields drop off quickly with distance, so 15 centimeters (about six inches) from a strong source is far better than resting on it.
  • Don't rest your watch on a phone, tablet, speaker, laptop or wireless charger.
  • Be careful with magnetic cases and bags. Keep a watch away from magnetic clasps and closures.
  • Store watches in a drawer or box away from electronics and magnets, not on a bedside table next to a phone charger.
  • Travel smart. In a bag, keep your watch away from headphones, speakers and magnetic clasps.
  • Check occasionally. If your watch's rate jumps, run the compass test before you do anything else.

How this applies to Vardesso watches

If your Vardesso watch has a mechanical movement, magnetism is one of the first things to check when it suddenly gains time. Check your product page or manual to see whether the watch states any magnetic resistance, as this varies by movement and case construction. If your watch is quartz or has other electronics, don't use a demagnetizer on it. If the compass test shows magnetism and you're not confident demagnetizing it yourself, contact Vardesso or a watchmaker.

Questions and answers

How do I know if my watch is magnetized?

Usually it suddenly runs fast or erratically. A compass test confirms it: if the needle swings toward the watch or follows it, the watch is probably magnetized.

What does a magnetized watch do?

It typically gains time, sometimes minutes a day, because the hairspring coils stick together and shorten the spring. Severe cases can stop the watch.

Can a magnetized watch be fixed?

Yes. A demagnetizer, in a watchmaker's hands or at home, usually fixes it in seconds, and the watch returns to normal timekeeping.

How do I demagnetize a watch at home?

Use a watch demagnetizer according to its instructions: place the watch on it, switch it on and slowly pull the watch away before switching it off. Never use a permanent magnet.

How do I test a watch with a compass?

Lay a compass flat and move the watch slowly around it a centimeter or two away. If the needle swings toward the watch or follows it, the watch is likely magnetized.

Can a phone magnetize a watch?

A phone itself usually has weak magnets, but phone cases with magnetic closures, speakers and wireless chargers can, especially at close range or over time.

Can a laptop magnetize a watch?

It can. Laptops contain magnets and electronics. Don't rest your wrist or watch on the lid or palm rest for long.

Does magnetism make a watch run fast or slow?

Usually fast. The hairspring coils stick, shortening the spring. Occasionally the effect is erratic.

How much magnetism can a watch handle?

A watch that meets the ISO 764 baseline withstands about 4,800 amperes per meter, roughly 60 gauss. Watches with extra shielding or special alloys resist far more.

Can quartz watches be magnetized?

Not in the same way. A strong magnet can disturb a quartz watch's motor temporarily, but quartz watches don't have a hairspring that sticks.

Can I use a magnet to demagnetize my watch?

No. A permanent magnet makes things worse. Use a proper demagnetizer or a watchmaker.

How far should I keep my watch from magnets?

As a rough guide, at least 15 centimeters (6 inches) from strong sources, and don't rest it on a phone, speaker, laptop or magnetic clasp.

Will airport security magnetize my watch?

Airport scanners are generally not a major risk to a watch, but some security gates and medical equipment produce strong fields. Wear or pack the watch as you normally would and test it if its rate changes afterward.

Can a watchmaker tell if my watch is magnetized?

Yes, with a compass or a timing machine, and they can demagnetize it in a minute or two.

Keep reading

  • Magnetism: The Hidden Reason Watches Run Fast (/blogs/movements/watch-magnetism)
  • What to Do When Your Watch Runs Fast or Slow (/blogs/watch-care/watch-running-fast-or-slow)
  • Positional Variance (/blogs/movements/positional-variance)
  • The Balance Wheel and Hairspring (/blogs/movements/balance-wheel-and-hairspring)
  • Regulating a Watch (/blogs/movements/regulating-a-watch)
  • What Is a Quartz Movement? (/blogs/movements/what-is-a-quartz-movement)
  • How Accurate Should a Watch Be? (/blogs/watch-basics/how-accurate-should-a-watch-be)

Sources